|
Go to Main
Help Menu
Complete Help
coming soon.
Configuration Menu: Click to be brought to the
configuration menu of the Model 100.
Help: Click to
go to the main Model 100 Help menu (opens in a separate window).
Indicator Status
On-board LEDs:
Select Disabled or Enabled. Factory default is Disabled.
Applet Virtual LEDs:
Select Disabled or Enabled. Factory default is Disabled.
Submit: Click
Submit to send the Output Status changes to the system.
Trigger 1 (T1)
Threshold (dB):
Enter the Trigger 1 threshold in dB, up to 3 characters. Factory default is
84.
Measurement Type:
Select SPL Fast, SPL Slow, Leq 10 sec, Leq 1 min, Leq 5 min, Leq 10 min,
Leq 15 min, Leq Continuous, L10, User Ln,
or L90. Factory default is SPL Fast.
Trigger 2 (T2)
Threshold (dB):
Enter the Trigger 1 threshold in dB, up to 3 characters. Trigger 2
threshold should be greater than Trigger 1 threshold. Factory default is
94.
Measurement Type:
Select SPL Fast, SPL Slow, Leq 1 sec, Leq 10 sec, Leq 1 min, Leq 5 min, Leq 10 min,
Leq 15 min, Leq Continuous. Factory default is SPL Fast.
Submit: Click
Submit to send Trigger 1 and Trigger 2 changes to the system.
Green LEDs
Description:
Enter the description, up to 15 characters. Factory default is Signal
Present.
Output
Response:
Select Disabled, Always On, Real-Time, Hold for 2 sec, Hold for 8 sec,
Blink for 4 sec, or Blink for 30 sec. Factory default is Real-Time.
Trigger
Condition:
Select ≥ T1,
< T1, ≥ T2, < T2, or ≥ T1 and < T2. Factory default is
≥ T1 and < T2.
Red LEDs
Description:
Enter the description, up to 15 characters. Factory default is Peak.
Output
Response:
Select Disabled, Always On, Real-Time, Hold for 2 sec, Hold for 8 sec,
Blink for 4 sec, or Blink for 30 sec. Factory default is Real-Time.
Trigger
Condition:
Select ≥ T1,
< T1, ≥ T2, < T2, or ≥ T1 and < T2. Factory default is
≥ T2.
Submit: Click
Submit to send the LED and Status DC Output changes to the system.
Output Closure:
Select Not
Available, Disabled, Enabled, or Follows T2. Factory default is Disabled.
Submit: Click
Submit to send the Output Closure changes to the system.
Error Status: Shows
--- or current error. See Configuration Menu Help
for a description of all error messages.
Clear Error Message:
Click to clear error message.
Studio Technologies,
Inc.: Clicking this link will bring you to the SPLnet website home page.
|
